Simulation Draws

This window is the first step when performing History draw simulation. The tickets selected in this window will be treated as winning numbers and their History values will be calculated and summarized in Draw Simulation table.

Click button Select in the upper part of the window to open popup menu to select the tickets for draw simulation. The content of the lower part of the window differs depending which window the simulation is started from.

Click button Run Simulation at the bottom of the window to start Draw Simulation.

Segmentation Simulation

Click menu History - Latest to open Latest History window, switch to Segmentation mode and toggle Draw Simulation button. Then click run.png button to open Simulation Draws window.

The lower part of the window contains controls to adjust segmentation filter settings. The filter will be applied to simulation tickets and the simulation results will be calculated only from tickets the filter accepts.

simulation_input1.png

The example above invokes draw simulation for all possible number combinations in Expert Lotto 6/49 demo lottery. History values will be calculated only for tickets that have two to four numbers from Segment 1 in Level 0 AND one to three numbers from Segment 2 in Level 0 AND one to three numbers from Segment 3 in Level 0. All other tickets are discarded and don't affect simulation results.

Button pkg_filter.png at the bottom left corner of the window applies the segmentation filter on tickets in the Package. The button is enabled only when the Package isn't empty.

Summary Simulation

Click menu History - Summary to open Summary History window, switch to Simulation mode and click run.png button to open Simulation Draws window.

There is Use filter check box at the lower part of the window. Tick the check box and click Select button to choose a filter to be applied to simulation tickets. Only tickets accepted by the filter will be used to calculate History values. Using a filter during Draw Simulation enables comparing simulation results of pre-filtered tickets with the simulation results of e.g. all possible number combinations.

Using a filter in Simulation Draws window is just a shortcut for the following steps:

  1. Insert the simulation tickets into the Package.
  2. Filter Package tickets with selected ticket filter.
  3. Run Draw Simulation for Package tickets.