by Jerzy » Thu Jan 03, 2008 4:33 am
Padawan,
I confirm your findings.
Before you reported this problem, I experimented with the single segment 1 and with all 3 segments together. I was able to set the number of matches to the required value. And when I back-tested the filter against known drawings, it seemed to work correctly.
Initially I did not check thoroughly the function of all spinbuttons. But I noticed that the spinbuttons for Seg3 worked independently from each other, and Min could be set to a value Higher than Max. I did not consider this important, but rather a cosmetic problem. What really matters, is the setting which can be entered, and it can.
Increasing the value of Seg3 min from 0 to 11 increases also the value of Seg2 Max to 11. Decreasing Seg2 Max from 11 to 0 decreases also Seg3 Min to 0. But increasing the value of Seg2 from 0 to 11 has no effect on Seg3 Min. Initially I did not see this defect.
I believe that Joe would fix these errors and it would not be difficult.
Best Regards
Jerzy