Playslip Margins
Posted: Wed Dec 15, 2010 11:36 am
Hi Stan
I have been setting up the playslips in the Beta version. When I try to adjust the print margins (top & Left) it will adjust the numbers to decimal points, but will not save numbers if they contain decimal points. e.g. if I make the top margin 5mm & the left margin 60mm it will seem to retain the settings when I close Expert lotto & go back into it again. However, if I make the top margin say 5.8mm & the left margine say 60.7mm, then close Expert lotto & go back into it again it will not retain the figures, as they have decimal points in them. When using version 4, it used to retain the figures even when they had decimal points in them. I find I need decimal points in these settings in order for the playslips to print out correctly. Thanks Stan
I have been setting up the playslips in the Beta version. When I try to adjust the print margins (top & Left) it will adjust the numbers to decimal points, but will not save numbers if they contain decimal points. e.g. if I make the top margin 5mm & the left margin 60mm it will seem to retain the settings when I close Expert lotto & go back into it again. However, if I make the top margin say 5.8mm & the left margine say 60.7mm, then close Expert lotto & go back into it again it will not retain the figures, as they have decimal points in them. When using version 4, it used to retain the figures even when they had decimal points in them. I find I need decimal points in these settings in order for the playslips to print out correctly. Thanks Stan